Kontroller- BlueSolar PWM Charge Controller-LCD&USB 12/24V- 20A

Kontroller- BlueSolar PWM Charge Controller-LCD&USB 12/24V- 20A

- Liquid crystal display - for status monitoring and set-up

Load output Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage. Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual. The connect and disconnect voltages are adjustable. Day/night timing of the load output This option allows for a pre-set ON-time after dusk. Programmable battery charge algorithm Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only) Two 5 Volt USB outputs Maximum current (both outputs combined): 2A 

Rated charge current  20A Automatic load disconnect Yes

Maximum solar voltage  55V

Self-consumption < 10 mA

Load output Manual control + low voltage disconnect +timer Protection Battery reverse polarity (fuse) Output short circuit Over temperature Overload protection Shut down after 60 s in case of 130% load Shut down after 5 s in case of 160% load Short circuit: immediate shut down Grounding Common positive Operating temp. range -35 to +60°C (full load) Humidity (non-condensing) Max 95% BATTERY

Charge voltage 'absorption' Factory setting: 14,4V / 28,8V

Charge voltage 'float' (2) Factory setting: 13,7V / 27,4V

 Low voltage load disconnect Factory setting: 11,2V / 22,4V

 Low voltage load reconnect Factory setting: 12,6V / 25,2V